made for Balboa by Tecmark
The Balboa Hot Tub Pressure Switch is designed to fit M3 Heater tubes and can be found on numerous brands of hot tubs such as 'Spaform Spas' and 'Master Spas'.
This component is easily tested for faults, presuming every other aspect of the hot tub works fine and the filters are clean and you have good water flow, simply loop out your existing pressure switch with a small piece of wire and if the problem is resolved replace for a new switch.
*Note: We advise not to adjust the pressure adjustments on Balboa Pressure Switches, because it usually means you have another problem on the hot tub and the switch is ok
Width (cm): 5
Height (cm): 7.5
Connection: 2 x Spade
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Heater Guides