Made by LX Whirlpool
LX H30-R1 Heater With Control Line (Pressure Switch) - Chinese Hot Tub Heater
This LX H30-R1 heater fits 1.5" plumbing which means the thread on the union connectors is 61mm, the length of the tube on its own is 25cm without the unions, it has 2 cable coming out the side, one is a control line and the other is for the power (excluding the green earth wire).
Its usually found fitted to Chinese hot tubs with TCP-8 and KL8 control systems like in Spa Serve Spas, but can be used for upgrades and repairs on any make or model of hot tub or spa.
Inside the heater, under the cap it has a pressure switch and 2 high limit detectors.
To get the right LX H30-R1 heater:
There are 2 sizes of H30-R1 Heater and also 2 options with or without the extra pressure switch cable, this is the smaller size with the extra pressure switch cable. Please double check the detail to get this right!
- 3kw Element Fitted
- Fits 1.5" Plumbing (61mm unions)
- Length including fittings unions 29.5cm (tube only 25cm)
- Width of metal tube 5cm
Comes complete with:
- 1m power cable,
- 1.5" female hot tub heater unions and tail pieces,
- 2 new seals and factory fitted element.
- Pressure Switch with extra separate cable coming out the side.
Make sure their are no blockages or restrictions of water flow, filters are clean and all air is removed from the heater tube before switching on the power.
*Please note this Chinese heater has a second cable coming from it that goes to the pressure switch built inside it.