Made by Aqua-Flo pumps
This pump is used to circulate water in hot tubs and spas, its usually located just before the heater tube and. The pump is made up of an Impeller housing and a motor made by Emerson.
Separate parts are available for this pump.
Please note the wet end is easily rotated to point left or right by loosening the through bolts on the rear of the motor, also that the width of the thread on wet end union fittings is 6.1cm or 2 1/2".
Diagram showing the direction the wet end can be rotated to.
Aqua-flo Circ master specification information:
- 1.5" intake and outlet diameter (Click here for more detail)
- The Spa pump comes with 3 pin JJ cord but this can easily be replaced for your existing wire should this be required.
- This hot tub pump is found on a variety of hot tubs including:Hydrospa, Spaform, Hot Tubs Direct, Aegean, Down East, Master Spa, Leisurerite and Sunrise.
Used on may spas for example: Hydrospa, Spaform, Hot Tubs Direct, Aegean, Down East, Master Spa, Leisurerite and Sunrise.
Manufacturers CodePart Number: 02593001-2001
Wet End Frame Size: 48
Pump Horse Power: 1/15
Pump Speeds: 1
Length (cm): 33
Width (cm): 21
Height (cm): 17.5
Motor HP: 1/15
Pump KW: Unknown
Pump Amps: 0.63
Pump RPM: 1425
Impellor HP Size: 1
Includes Cable: Yes
Wet End Suction Location: Middle
Wet End Return Location: Right
Wet End Return Union Size: 1.5
Wet End Suction Union Size: 1.5
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides