Made by Balboa
This pump is a 2 speed 1.5hp pump which is small in size, the wet end is made by Vico (separate parts available), it is used in many hot tubs such as Hydrospa Spa's.
The Balboa hot tub pump is also a great replacement for the no longer produced HA440 pump made by Magnaflo and is called a HA440NG, the pump will be allot quieter and a little bit more powerful, but is a similar size and has the same connections.
*Note the pump will have to be raised 10mm to align the wet end perfectly with the previous plumbing.
Comes with a 4 core 3 meter cable with a 4 pin 'AMP' connector on the end, if this isn't the correct connector for your spa you will need to cut the cable and replace it for your existing cable connector.
If you are fitting this pump into a new system it comes with Comes with 2 x 63mm unions, 2 x 2" unions and 2 x 50mm unions.
Manufacturers CodePart Number: PW-HA443
Wet End Frame Size: 48
Pump Horse Power: 1.5
Pump Speeds: 2
Length (cm): 39
Width (cm): 19
Height (cm): 23
Motor HP: 0.43 / 1.86
Pump Amps: 1.5 / 5.7
Pump RPM: 1400 / 2800
Impellor HP Size: 2
Includes Cable: No
Wet End Suction Location: Middle
Wet End Return Union Size: 2
Wet End Suction Union Size: 2
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides
|Average Rating (1 Review): |
Sunday, 28 January 2018 | Phil
Straight forward like for like swap on pump. Arrived very quick. Very helpful and friendly people. Will use again.
Was this helpful to you? Yes / No
This review has not been appraised.