Made by EMG
The EMG 3hp single speed pump motor can only be used as a boost pump, and should never be used on a heating circuit. Its a 56 frame motor and can be seen in larger hot tubs due to its power, in most hot tubs it will be labelled as 'Waterway' which is a re-branding due to the massive amount they purchase and supply.
* Please Note: A cable is not provided with this motor*
Will not fit Aqua-Flo wet ends, due to the distances between the mounting bolts and the length of motor shaft.
To enable this hot tub motor to pump water around it needs to be fitted with the correct wet end impeller housing, in this particular case you will need a 56 frame waterway wet end to ensure the correct fit on to your hot tub plumbing, but may also fit Vico 56 frame wet ends as well.
(If your replacing your current motor this hot tub motor you may also need a shaft seal kit) Hot Tub Seal Kits
Manufacturers CodePart Number: PM-E5631
Wet End Frame Size: 56
Pump Speeds: 1
Length (cm): 28
Width (cm): 17.5
Height (cm): 20.5
Motor HP: 3.21
Pump KW: 2.25
Pump Amps: 12.8
Pump RPM: 2840 high
Includes Cable: No
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides