Home > Electrical Parts > Hot Tub Pumps > HydroAir Pumps
Availability:
More than 10 in stock
Manufacturers Code: PS201
This is used to seal the impeller housing in a Spaform GC150 hot tub or spa wet end. Most Commonly seen on Spaform hot tubs (blue Wet End).
Shaft seals are made of 2 parts a spring with a carbon bearing on the end and a ceramic ring when put together they produce a water tight seal that fits inside the wet end of a hot tub impeller housing.
Fitting
They are easy to replace, when fitting make sure you don't break, crack or get dirt in the bearing faces.
Hot Tub Repair Tip: Shaft seals can wear out through age, but it is usually chemicals that cause the break down and leak, if when you remove your shaft seal the carbon comes of on your hands, then either you are doing your chemicals wrong or using the wrong type (For example - Never use Swimming Pool Chemicals in your spa - they are designed for a different purpose).
MPN: PS-201
Quick Find Code: 16003ABrand: U S SealsWidth (cm): 3.5Combined Length (cm): 3.4Width of Rubber Seal (cm): 3.5
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides
Easily fitted with no hassle.
Was this helpful to you? Yes / No
This review has not been appraised.
Excellent