Made by Gecko
DTec2 Pressure switch used on Gecko heater tubes.
Replaces the red DTec Gecko pressure switch
This is a original part made by Gecko, when fitting use a little a little PTFE tape to create a seal.
Note: If using this part to tec switch you may need to check the height of where its due to be fitted because its a little taller, see images above and description of size.
Connections
- Connections: 2 x Spade
- Thread: 1/8" MPT
- PSI: 2
- Version DTec2
This product can be used as a replacement part on many kinds of hot tub that use Gecko parts like: HotSpring Spas and Gecko control systems, SSPA1 /2 and MSPA
Testing
This component is easily tested for faults, presuming every other aspect of the hot tub works fine and the filters are clean and you have good water flow, simply loop out your existing pressure switch with a small piece of wire and if the problem is resolved replace for a new switch.
*Note: We do not recommend to adjust the pressure switch setting on the top of a Gecko pressure switch, this has been set by the manufacturer to a specific pressure, if the problem still persists after replacement you will most probably have a different fault on the hot tub or spa.
Related Products
