Made by Balboa WaterGroup
GS501SZ Complete Control System
This system consists of a GS501SZ control box (3kW Heater), a VL701S programmable control panel (18.7cm x 8.3cm) and 4 cables, 1 x 2 speed pump, 2 circ pump / blower or ozone cable and a 2 pin light cable.
Note on VL701S Panel
This panel has a mode button which means you cen set the time and programme when the spa filters.
This system is made of M7 Technology which is a Balboa twin sensor control system, this means you don't need to drill a hole for a temperature thermostat, their is no pressure switch or high limit sensor, the system works by sensing the difference between the two thermostats, pre heater is the current temperature post heater is the hi limit and if both sensors are the same the element is working.
The M7 systems are great for upgrades on hot tubs because their so easy to fit into a system, this also applies if your building a hot tub from new.
If you need more help getting the right hot tub part then please get in touch.
Manufacturers CodePart Number: PK-50144
Length (cm): 50
Width (cm): 12
Height (cm): 27
Plumbing Size (Inch's): 2
Includes: All Cables
Pump 1: Single or dual speed Pump
Pump 2: No Connection
Pump 3: No Connection
Air Blower: Ready
Heater: 3kw M7
Light option: 12 Volt
Topside Controller Included: Yes VL701S
Circulation Pump: Ready
Radio TV/AV: Ready
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Electrical Guides
|Average Rating (1 Review): |
Thursday, 11 June 2015 | Tim
What can I say...
Outstanding again !!!!
Was this helpful to you? Yes / No
This review has not been appraised.