Made by U S Seals
Manufacturers Code: PS201
This is used to seal the wet end impeller housing in a ITT spa Pump. Most Commonly seen on Spaform hot tubs (Black Wet End) and will provide a secure and long lasting seal for your hot tub pump.
Shaft seals are made of 2 parts a spring with a carbon bearing on the end and a ceramic ring when put together they produce a water tight seal that fits inside the wet end of a hot tub impeller housing.
They are easy to replace, when fitting make sure you don't break, crack or get dirt in the bearing faces.
Hot Tub Repair Tip: To ensure correct parts are ordered, you will need to remove the old shaft seal from your existing pump to compare the size the shaft seal to the information given here as there are a variety of different types.
Manufacturers CodePart Number: PS-201
Brand: U S Seals
Width (cm): 3.5
Combined Length (cm): 3.4
Width of Rubber Seal (cm): 3.5
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides
|Average Rating (1 Review): |
Thursday, 18 May 2017 | AW
Delivery was prompt and part has been fitted and no leaks so far. One thing that should be pointed out is that the component with the integral spring has a stainless steel washer assembly at the extreme end that has to be discarded . I assume this water seal is common to more than one pump type and some pumps may require this to be left in place. Took me 30 seconds to work it out so not an issue and am pleased with the part.
Was this helpful to you? Yes / No
This review has not been appraised.