Made by LX Pumps
This LX pump wet end is easy to replace and comes complete with a new shaft seal, impeller and wet end seal.
*fits LX JA75 / JA100 pumps only*
LX Whirlpool JA75 / JA100 circulation pump, if you need a new wet end due to a crack / leak or excess wear then this will fit straight on.
- Remove screws from faceplate
- Remove bolts that go through the motor to hold the wet end on
- Unscrew the impellor anto clockwise
- Fit new wet end
- put a small amount of lubricant on plumbing seals tightening unions back on
For any other help or advice on hot tub parts please email or call.
Manufacturers CodePart Number: B450-05
Brand: LX Pumps
Length (cm): 12.6
Width (cm): 15.6
Height (cm): 17.5
Impellor HP Size: 1hp
Wet End Suction Location: Bottom
Wet End Return Location: Center
Wet End Return Union Size: Fits 1.5" Plumbing - 6.1cm wide
Wet End Suction Union Size: Fits 1.5" Plumbing 6.1cm wide
Plumbing Size (Inch's): 1.5" Plumbing
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides