Made by Gecko
Manufacturers Code: SSPA1 - Gecko S-Class Control Box
This is a white control box with a 15" 2kw heater tube attached to the bottom, it can be seen on many hot tubs and spas and is sometimes re relabelled by manufacturers like Hot Spring Spas, it will run a main pump, a circulation pump and either a boost pump or air blower.
- High limit and Thermostat included
- Pressure Switch Included (Tecmark Pressure Switch)
- Heater Length 15" (38cm)
- 230 volts, 2.0Kw 8-8.5 amps
Note: if you have a 'Hot Spring Spa' you will need to change the main chip on the PCB (Printed Circuit Board) with your existing one to enable it to work properly with your existing topside control panel.
For technical installation detail or testing help please contact our office either by email or telephone.
Manufacturers CodePart Number: sspa1
Length (cm): 32
Width (cm): 12
Height (cm): 27
Connection: JJ Moulded Plug
Plumbing Size (Inch's): 2
Pump 1: Single or dual speed pump + circulation pump if required
Pump 2: Optional Without Blower
Air Blower: Optional Without Pump Two
Light option: 12 Volt
Ozone: If Required
Topside Controller Included: No
Topsides Compatible: TSC-9, TSC-18, TSC-19, TSC-35
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Heater Guides
|Average Rating (1 Review): |
Tuesday, 29 March 2016 | Colin
Fantastic service and support offered by Jon and the team ,hot tub back up and running for Easter
Was this helpful to you? Yes / No
This review has not been appraised.