Home > Electrical Parts > Heaters > Heater Parts
Availability:
More than 10 in stock
The Tecmark Pressure Switch screws into the heater tube inside many hot tubs and spas, it has an adjustment on the top but this should not be moved and is factory set.
Used in Gecko, Hydroquip & Spa Builders control boxes.
Connections
Testing
This component is easily tested for faults, presuming every other aspect of the hot tub works fine and the filters are clean and you have good water flow, simply loop out your existing pressure switch with a small piece of wire and if the problem is resolved replace for a new switch.
*Note: We do not recommend to adjust the presure switch setting on the top of a Tecmark pressure switch, this has been set by the manufacturer to a specific pressure, if the problem still persists after replacement you will most probably have a different fault on the hot tub or spa.
MPN: TDI-3902 3903
Quick Find Code: 31602Brand: TecmarkWidth (cm): 5Height (cm): 5.8Connection: 2 x Spade
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Heater Guides
Excellent service with prompt delivery . Switch is exactly what we needed for our hot -tub which is working perfectly now .
Was this helpful to you? Yes / No
This review has not been appraised.
Excellent service and delivery spot on. Got the tub up and running again.
VERY IMPRESSED WITH THE EFFICIENCY COMMUNICATION - HIGHLY RECOMMENDED