Made by Waterway
Used on 2.5HP or 3HP Pumps with Waterway Wet Ends.
New style means the impeller has been re-designed to optimise water flow through and out the wet end housing
Note the dimensions are slightly different.
The perfect hot tub fitting for your replacement hot tub pumps. This particular hot tub Impeller can work with numerous different models of hot tub pumps. If you would like advice on choosing the correct Hot tub Impeller for your spa please do not hesitate to contact us.
- The Waterway Executive Hot Tub Impeller is 23mm thick and requires a new shaft seal when fitted.
- Distance between front and rear plate: 15mm
We advise using the Waterway Hot Tub Pump Shaft Seal Kit for this very task.
Shaft seal and wear ring sold separately.
Manufacturers CodePart Number: 310-4180
Length (cm): 9cm
Width (cm): 11.1cm
Impellor HP Size: 5hp
Space Between Plates (cm): 1.5cm
Intake outer diameter: 5.5cm
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides
|Average Rating (1 Review): |
Thursday, 31 May 2018 | Anthony
Excellent service fast delivery
Was this helpful to you? Yes / No
This review has not been appraised.