Made by Waterway
Manufacturers Description - Waterway Euro Executive 56 frame Wet End
Designed to fit a 2.5 or 3 HP Motor (Max Amperage 9-13 Amps)
With this product you will receive the complete wet end assembly for waterway 56 frame hot tub pumps. Everything you need to replace your current wet end including the shaft seal.
Fits 2.5" pump unions. (Actual size 2.5" = 9.2cm).
Both suction and pressure have a flat smooth connection meaning that the o'ring would be attached to the union sleeve. The impeller is screwed on to the shaft which protrudes from the center of the hot tub pump body. The 56 Frame Waterway 5HP hot tub wet end fixes to the Hot tub pump body with 4 x small bolts. So is very easy to fit to your spa when replacing your Hot tub pump or just the wet end connection.
What is included in this Hot Tub Wet End unit?
- The housing,
- The face plate,
- The face plate o-ring,
- The 5.0hp impeller,
- The ceramic seal kit,
- This unit also includes 3 built in bleed screws.
Please Note: Although this wet end is labelled as 5HP it is commonly fitted to our 2HP Waterway Spa pumps and sold as a 2HP as a complete hot tub pump.
Manufacturers CodePart Number: 310-1750
Wet End Frame Size: 56
Width (cm): 20
Height (cm): 23
Impellor HP Size: 5
Wet End Suction Location: Middle
Wet End Return Location: Right
Wet End Return Union Size: 2"
Wet End Suction Union Size: 2" or 2.5"
Includes Seal: Yes
Please note all Hot tub Parts sold are UK Spec, which means designed for 230 V at 50Hz
Need More Detail?
At Hot Tub DIY we want to make it as easy as possible for you to repair or build your hot tub, the following guides relate to this product.
For a full list of guides please go to our Articles page and choose a section : Hot Tub Help Articles
Hot Tub Pump Guides
|Average Rating (1 Review): |
Thursday, 8 August 2019 | Gregory
fast service and the correct parts in stock and sensible prices
Was this helpful to you? Yes / No
This review has not been appraised.